Netgear RT314 사용자 설명서
Reference Guide for the Model RT311 and RT314 Internet Access Gateway Routers
2-2
Setting Up the Hardware
Local Network Hardware Requirements
The Model RT311 or RT314 Internet Access Gateway Router is intended for use in a network of
personal computers (PCs) that are interconnected by twisted-pair Ethernet cables.
personal computers (PCs) that are interconnected by twisted-pair Ethernet cables.
PC Requirements
To install and run the Model RT311 and RT314 routers over your network of PCs, each PC must
have the following:
have the following:
•
An installed Ethernet Network Interface Card (NIC).
•
A connection to the network via a hub or switch. If all PCs on the network will not run at the
same speed (10 Mbps or 100 Mbps), you need to use a dual-speed hub or switch. The Model
RT314 router provides a 4-port switch capable of either 10 Mbps or 100 Mbps operation.
Links operating at 100 Mbps must be connected with Category 5 cable.
same speed (10 Mbps or 100 Mbps), you need to use a dual-speed hub or switch. The Model
RT314 router provides a 4-port switch capable of either 10 Mbps or 100 Mbps operation.
Links operating at 100 Mbps must be connected with Category 5 cable.
Access Device Requirement
The shared broadband access device (cable modem or DSL modem) must provide a standard
10BASE-T Ethernet interface.
10BASE-T Ethernet interface.