Netgear RT314 사용자 설명서

Reference Guide for the Model RT311 and RT314 Internet Access Gateway Routers

2-8

Setting Up the Hardware

2.

Plug the other end into a serial port (such as COM1 or COM2) of your PC. 

To connect the router to the power adapter:

1.

Plug the connector of the power adapter into the 12 VDC adapter outlet on the rear panel of the 
router.

2.

Plug the other end of the adapter into a standard wall outlet.

3.

Verify that the PWR LED on the router is lit.

After connecting the power adapter to the router and a power source, the router powers on 
automatically. Complete the following steps to verify that power is correctly applied to the router:

1.

When power is first applied, verify that the PWR LED is on.

2.

Verify that the TEST LED begins to blink within a few seconds.

3.

After approximately 30 seconds, verify that:

a.

The TEST LED is not lit.

b.

The LOCAL LNK/ACT LEDs are lit for any local ports that are connected.

c.

The INTERNET LNK/ACT LED is lit.

If a LNK/ACT LED is lit, a link has been established to the connected device.

4.

If a LOCAL port is connected to a 100 Mbps device, verify that the 100 LED is lit.

You are now ready to begin configuration of your network, as described in the following chapter.

You must use a 9-pin to 25-pin adapter if your PC has only a 25-pin port 

available.