Netgear RT314 사용자 설명서

Reference Guide for the Model RT311 and RT314 Internet Access Gateway Routers

3-4

Preparing Your Network

d.

Select TCP/IP, and then click OK.

If you need Client for Microsoft Networks:

a.

Click the Add button.

b.

Select Client, and then click Add.

c.

Select Microsoft.

d.

Select Client for Microsoft Networks, and then click OK.

3.

Restart your PC for the changes to take effect.

After the TCP/IP protocol components are installed, each PC must be assigned specific 
information about itself and resources that are available on its network. The simplest way to 
configure this information is to allow the PC to obtain the information from the internal DHCP 
server of the Model RT311 and RT314 routers.

If you are using DHCP with the recommended default addresses, you can configure your PCs by 
following these steps:

1.

Install TCP/IP on each PC, leaving the PC configured to obtain configuration settings 
automatically (by DHCP).

2.

Physically connect the PCs and the router using a hub or a direct connection.

3.

Restart the router and allow it to boot.

4.

Restart each PC.

After your PC is configured and has rebooted, you can check the TCP/IP configuration using the 
Windows 95 and 98 utility winipcfg.exe (for Windows NT systems, use ipconfig.exe). 

If an ISP technician configured your PC during the installation of a broadband 

modem, or if you configured it using instructions provided by your ISP, you may need to 
copy the current configuration information for use in the configuration of your router. 
Refer to 

” on 

 or 

” on 

 for further 

information.