Netgear WAB102 사용자 설명서

Setting Up Basic Wireless Connectivity

The WAB102 dual band AP connects to your LAN via twisted-pair Category 5 
Ethernet cable with RJ-45 connectors.

Please follow these instructions to successfully install your WAB102. 

1.

Install the WAB102 Access Point. See below.

2.

Configure the Access Point. Turn to 

Before installing the WAB102 802.11 a+b Dual Band Wireless Access Point, you 
should make sure that your Ethernet network is up and working. You'll be 
connecting the access point to the Ethernet network so that computers with either 
802.11a or 802.11b wireless adapters will be able to communicate with computers 
on the Ethernet network. In order for this to work correctly, please verify that you 
have met all of the system requirements, shown on 

Please follow the steps below to successfully install the WAB102 802.11 a+b Dual 
Band Wireless Access Point.

The power adapter and cord shipped with the WAB102 limits the 

distance from an AC outlet. To overcome this, consider using 
NETGEAR’s POE101 Power Over Ethernet Adapter with a Category 5 
Ethernet cable like the one included with your WAB102. This adapter 
sends DC power through an Ethernet cable to enable you to power an 
access point in a remote location.

See 

 for the minimal system 

requirements for installing the WAB102.