Netgear WAB102 사용자 설명서
User’s Guide for the WAB102 802.11a+b Dual Band Wireless Access Point
Setting Up Basic Wireless Connectivity
15
For advanced users: To access the built-in Web Server home page on the
WAB102, we suggest that you have a DHCP server on the Ethernet Network.
If there is no accessible DHCP server, the WAB102 Access Point will default
to the IP address of 192.168.0.226 with a subnet mask of 255.255.255.0. You
will need to configure the IP address of the computer to be within the same
subnet for the initial configuration.
WAB102, we suggest that you have a DHCP server on the Ethernet Network.
If there is no accessible DHCP server, the WAB102 Access Point will default
to the IP address of 192.168.0.226 with a subnet mask of 255.255.255.0. You
will need to configure the IP address of the computer to be within the same
subnet for the initial configuration.
Having problems? Refer to
Chapter 4, “Troubleshooting”
.
4.
Click AP Setup to configure the WAB102 Access Point, and proceed to
the next section, Log In to the Access Point.
the next section, Log In to the Access Point.
Log In to the Access Point
To set up your access point, complete the following login steps:
1.
Click on the AP Setup link on the WAB102 Web Server home page.
2.
The Enter Network Password window will be displayed, as shown above.
Enter the default user name
Enter the default user name
admin
with the default password
1234
in this
window.
Note:
Both the user name and password are case sensitive.
You may change the password at any time after this point by choosing
Password from the AP Setup menu
Password from the AP Setup menu
3.
Click OK. The TCP/IP LAN Setup window will be displayed as shown below.
Configure Basic Setup Parameters
To set up your access point, complete the following: