Netgear WNR1000V2 사용자 설명서

4-2

Customizing Your Network Settings

The device name is a user-friendly name for the router. This name is shown in the Network on 
Windows Vista and the Network Explorer on all Windows systems. The Device Name field cannot 
be blank. The default name is WNR1000v2.

These are advanced settings that you might configure if you are a network administrator and your 
network contains multiple routers. The router is shipped preconfigured to use private IP addresses 
on the LAN side and to act as a DHCP server (see 

).

The router’s default LAN IP configuration is:

•

LAN IP address. 192.168.1.1

•

Subnet mask. 255.255.255.0

These addresses are part of the designated private address range for use in private networks and 
should be suitable for most applications. If your network has a requirement to use a different IP 
addressing scheme, you can make those changes in this screen.

The LAN IP settings are:

•

IP Address. The LAN IP address of the router.

•

IP Subnet Mask. The LAN subnet mask of the router. Combined with the IP address, the IP 
subnet mask allows a device to know which other addresses are local to it, and which must be 
reached through a gateway or router.

•

RIP Direction. RIP allows a router to exchange routing information with other routers. The 
RIP Direction selection controls how the router sends and receives RIP packets. Both is the 
default. 
–

When set to Both or In Only, the router incorporates the RIP information that it receives. 

–

When set to Both or Out Only, the router broadcasts its routing table periodically. 

•

RIP Version. This controls the format and the broadcasting method of the RIP packets sent by 
the router. (It recognizes both formats when receiving.) The default setting is Disabled. 

Note: If you change the LAN IP address of the router while connected through the 

browser, you will be disconnected. You must then open a new connection to the 
new IP address and log in again.