Netgear R7000 사용자 설명서

You can connect to the router’s network through a wired or WiFi connection. If you set up 
your computer to use a static IP address, change the settings so that it uses Dynamic Host 
Configuration Protocol (DHCP). 

You can connect your computer to the router using an Ethernet cable and join the router’s 
local area network (LAN).



Make sure that the router has power (its Power LED is lit).

Connect an Ethernet cable to an Ethernet port on your computer.

Connect the other end of the Ethernet cable to one of the numbered Ethernet ports.

Your computer connects to the local area network (LAN). A message might display on 
your computer screen to notify you that an Ethernet cable is connected.

You can connect to the router’s WiFi network with Wi-Fi Protected Setup (WPS) or you can 
find and select the WiFi network.



Make sure that the router has power (its Power LED is lit).

Check the WPS instructions for your computer or wireless device.

Press the WPS button on the router.

Within two minutes, on your computer or WiFi device, press its WPS button or follow its 
instructions for WPS connections.

Your computer or wireless device connects to the WiFi network.



Make sure that the router has power (its Power LED is lit).

On your computer or wireless device, find and select the WiFi network.

The WiFi network name is on the router’s label.

Join the WiFi network and enter the WiFi password.

The password is on the router’s label.

Your wireless device connects to the WiFi network.