Netgear DGN1000V3 사용자 설명서

The modem router can function either as a base station or as a repeater:

Wireless base station. The modem router acts as the parent access point, bridging 
traffic to and from the child repeater access point, as well as handling wireless and wired 
local computers. To configure this mode, you need to know the MAC address of the child 
repeater access point.

Wireless repeater. The modem router sends all traffic from its local wireless or wired 
computers to a remote access point. To configure this mode, you need to know the MAC 
address of the remote parent access point. 

For you to set up a wireless network in a WDS, 

t

he following conditions need to be met for 

both access points:

Both access points need to use the same SSID, wireless channel, and encryption mode.

Both access points need to be on the same LAN IP subnet. That is, all the access point 
LAN IP addresses are in the same network.

All LAN devices (wired and wireless computers) need to be configured to operate in the 

same LAN network address range as the access points.

The channel selection on the access points cannot be Auto (see 

30).

When you use the wireless repeating function, WPS becomes disabled.

The wireless repeating function works only in hub and spoke mode. The units cannot be 
daisy-chained. You need to know the wireless MAC addresses of all units. First, set up the 
base station, and then set up the repeater.



Select ADVANCED > Advanced Setup > Wireless Repeating Function.

The Wireless Repeating Function screen displays. The wireless MAC address of the 
modem router is displayed onscreen.

Select the Enable Wireless Repeating Function check box.