Netgear WGR826V 사용자 설명서

Preparing Your Network

C-1

This appendix describes how to prepare your network to connect to the Internet through the 
WGR826V 54 Mbps Wireless Router with Phone Adapter and how to verify the readiness of 
broadband Internet service from an Internet service provider (ISP).

You need to prepare these three things before you begin:

To use the WGR826V Wireless Router on your network, each computer must have an 802.11g or 
802.11b wireless adapter or an installed Ethernet Network Interface Card (NIC) and an Ethernet 
cable. If the computer will connect to your network using an Ethernet NIC at 100 Mbps, you must 
use a Category 5 (Cat 5) cable such as the one provided with your router. For an explanation of 
Ethernet cabling, see 

. The cable or DSL broadband modem must 

provide a standard 10 Mbps (10BASE-T) or 100 Mbps (100BASE-Tx) Ethernet interface. 

The WGR826V includes a built-in Web Configuration Manager. To access the configuration 
menus on the WGR826V, your must use a Java-enabled Web browser program which supports 
HTTP uploads such as Microsoft Internet Explorer or Netscape Navigator. Use Internet Explorer 
or Netscape Navigator 4.0 or above. 

Note: If an ISP technician configured your computer during the installation of a 
broadband modem, or if you configured it using instructions provided by your ISP, you 
may need to copy the current configuration information for use in the configuration of 
your firewall. Write down this information before reconfiguring your computers. Refer 
to 

” on 

 or 

 for 

further information.