Netgear WGR826V 사용자 설명서

7-4

Setting Up Advanced Router Configurations

When you specify a reserved IP address for a computer on the LAN, that computer will always 
receive the same IP address each time it access the router’s DHCP server. Reserved IP addresses 
should be assigned to servers that require permanent IP settings. 

To reserve an IP address: 

1.

Click the Add button. 

2.

In the IP Address box, type the IP address to assign to the computer or server.

 

(choose an IP address from the router’s LAN subnet, such as 192.168.15.X) 

3.

Type the MAC Address of the computer or server. 

 

(Tip: If the computer is already present on your network, you can copy its MAC address from 
the Attached Devices menu and paste it here.) 

4.

Click Apply to enter the reserved address into the table. 

Note: The reserved address will not be assigned until the next time the computer contacts the 
router's DHCP server. Reboot the computer or access its IP configuration and force a DHCP 
release and renew. 

To edit or delete a reserved address entry: 

1.

Click the button next to the reserved address you want to edit or delete. 

2.

Click Edit or Delete.

Static Routes provide additional routing information to your router. Under normal circumstances, 
the router has adequate routing information after it has been configured for Internet access, and 
you do not need to configure additional static routes. You must configure static routes only for 
unusual cases such as multiple routers or multiple IP subnets located on your network.

From the Main Menu of the browser interface, under Advanced, click on Static Routes to view the 
Static Route menu, shown below.