Netgear WG302NA 사용자 설명서
Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302
Basic Installation and Configuration
3-3
July 2005 v3.0
Default Factory Settings
When you first receive your WG302, the default factory settings will be set as shown below. You
can restore these defaults with the Factory Default Restore switch on the rear panel — see
can restore these defaults with the Factory Default Restore switch on the rear panel — see
FEATURE
FACTORY DEFAULT SETTINGS
User Name (case sensitive)
admin
Password (case sensitive)
password
Operating Mode
Access Point
Access Point Name
netgearxxxxxx where xxxxxx are the last six
digits of the wireless access point's MAC address
digits of the wireless access point's MAC address
Built-in DHCP client
Built-in DHCP server
DHCP client disabled
DHCP server disabled
DHCP server disabled
IP Configuration
(if DHCP server is unavailable)
IP Address: 192.168.0.228
Subnet Mask: 255.255.255.0
Gateway: 0.0.0.0
Subnet Mask: 255.255.255.0
Gateway: 0.0.0.0
Network Name (SSID)
NETGEAR
Broadcast Network Name (SSID)
Enabled
802.11g Radio Frequency Channel
11
AutoCell RF Management
AutoCell Enhanced RF Security ‘stealth’ mode
Enabled
Disabled
Disabled
WEP/WPA
Disabled
Restricting connectivity based on MAC Access
Control List
Disabled
Spanning Tree Protocol
Enabled
Time Zone
GMT
Time Zone Adjust for Daylight Saving TIme
Disabled
SNMP
Enabled but Trap forwarding is disabled
Secure Telnet
Enabled
SugerG Mode
Disabled
WMM Mode
Disabled