Netgear WG302NA 사용자 설명서

5-10

Advanced Configuration

1.

Configure the Operating Mode of the WG302 Access Points.

–

WG302 (AP1) on LAN Segment 1 in Point-to-Point Bridge mode with the Remote MAC 
Address of AP2.

–

Because it is in the central location, configure WG302 (AP2) on LAN Segment 2 in 
Point-to-Multi-Point Bridge mode. The MAC addresses of the adjacent APs are required 
in AP2.

–

Configure the WG302 (AP3) on LAN 3 in Point-to-Point Bridge mode with the Remote 
MAC Address of AP2.

2.

Verify the following parameters for all access points:

•

Verify that the LAN network configuration the WG302 Access Points are configured to 
operate in the same LAN network address range as the LAN devices

•

Only one AP is configured in Point-to-Multi-Point Bridge mode, and all the others are in 
Point-to-Point Bridge mode.

•

All APs must be on the same LAN. That is, all the APs LAN IP address must be in the 
same network.

•

If using DHCP, all WG302 Access Points should be set to “Obtain an IP address 
automatically (DHCP Client)” in the IP Address Source portion of the Basic IP Settings 
menu.

'Master' AP in
Point-to-Multi-Point
Bridge Mode

AP in
Point-to-Point
Bridge Mode

AP in
Point-to-Point
Bridge Mode

E T H E R N E T

R E S E T

5 - 1 2 V D C

E T H E R N E T

R E S E T

5 - 1 2 V D C

E T H E R N E T

R E S E T

5 - 1 2 V D C