Netgear RT338 사용자 설명서
Model RT338 ISDN Router Installation Guide
2. Connect the analog devices to the phone ports (Phone 1 and Phone 2,
respectively).
3. Connect the ISDN line from the router to the ISDN wall connection.
Use the black cable that is provided.
4. Connect a network manager workstation to the RS-232 port. This step
is optional.
5. Connect the DC power adapter cable to the power outlet on the rear
panel of the switch and plug the power adapter into the wall outlet.
Do the following to prepare your router:
•
Order ISDN service from the phone company.
•
Configure your PC to use the TCP/IP networking protocol.
•
Order Internet service from an Internet service provider (ISP).
The following section provides an overview of the requirements.
Ordering an ISDN Line
Contact the ISDN sales center of the phone company and order an ISDN Basic
Rate Interface (BRI) phone line. In North America, provide the phone company
with an ISDN ordering code (IOC). NETGEAR recommends codes IOC “U” or
EZ-ISDN1 for the Model RT338 router. Additional information about ordering
an ISDN line can be found in the
Rate Interface (BRI) phone line. In North America, provide the phone company
with an ISDN ordering code (IOC). NETGEAR recommends codes IOC “U” or
EZ-ISDN1 for the Model RT338 router. Additional information about ordering
an ISDN line can be found in the
Model RT338 ISDN Router Installation Guide
.
When the ISDN line is installed, make sure you have the following information:
•
ISDN directory number(s)
•
Service profile identifier numbers (SPIDs) (North America only)
•
Switch type and protocol of the switch (such as National ISDN NI-1) used
at the telephone company (North America only)
at the telephone company (North America only)
Order any additional ISDN or phone service at this time.
Setting up Your Network
The Model RT338 router uses the Internet Protocol (IP). To access the Internet
using the Model RT338 router, all PCs must have TCP/IP installed and selected
as their networking protocol. TCP/IP is built into Windows® 95, Windows 98,
and Windows NT® but must be enabled and configured. Refer to “Configuring
TCP/IP Properties” for instructions to install IP networking.
using the Model RT338 router, all PCs must have TCP/IP installed and selected
as their networking protocol. TCP/IP is built into Windows® 95, Windows 98,
and Windows NT® but must be enabled and configured. Refer to “Configuring
TCP/IP Properties” for instructions to install IP networking.
In an IP network, all PCs must be assigned IP addresses. Most LANs use private
IP addresses. These addresses are assigned automatically by the Model RT338
router whenever a PC reboots. Refer to “Using Private IP Addresses” for
instructions to use private IP addressing.
IP addresses. These addresses are assigned automatically by the Model RT338
router whenever a PC reboots. Refer to “Using Private IP Addresses” for
instructions to use private IP addressing.
Prepare the Router