Netgear N450/CG3000Dv2 사용자 설명서

Configure your wireless computers with the same WPA2 or WPA 
settings as your modem router so that you can connect. 

b.  Depending on the WPA setting that you select, enter the required information.

For WPA-PSK or WPA2-PSK, enter the pre-shared key, which is a password between 
8  and 63 characters. The default WPA password appears on the label of your modem 
router.

By default, the modem router is set up to work with WPA and WPA2 
wireless security, both of which are newer than WEP. Typically, the 
only reason you might need to set up WEP would be to allow access 
to older wireless computers or devices that cannot support WPA.

Click the Apply button.

If you plan to use WPS, and you want to keep your wireless settings 
the same, go to the Advance Wireless Settings screen and make sure 
that the Keep Existing Settings check box is selected. See 

Wi-Fi Protected Setup (WPS) can be a quick way to automatically set up your modem 
router’s wireless network and set up your wireless computer to connect to it at the same time. 
WPS is relatively new technology, so before you decide to use it, check to make sure that 
your wireless computers and devices support WPS. NETGEAR calls WPS Push 'N' Connect.

Look for the WPS symbol 

 on all the computers that connect wirelessly to the modem 

router. If you do not see the WPS symbol 

 on all the computers that connect to the 

18). After that, you can still use WPS to set up the wireless 

connection for the computers that support WPS.

All WPS-capable products should be compatible with the modem 

router. For more information about the WPS standard, visit 

). 

Two Push 'N' Connect methods are available, WPS button and PIN (personal identification 
number).