Netgear WG602V4 사용자 설명서

5-2

Troubleshooting

•

Make sure the cable connectors are securely plugged in at the access point and the network 
device (hub, switch, or router).

•

Make sure the connected device is turned on.

•

Be sure the correct cable is used. Use a standard Category 5 Ethernet patch cable. If the 
network device has Auto Uplink™ (MDI/MDIX) ports, you may use a cross-over cable. See 
the Reference Manual for a full explanation of cable types.

The wireless access point’s antenna is not working.

•

If the Wireless LAN activity light stays off, disconnect the adapter from its power source and 
then plug it in again. 

•

Make sure the antenna is tightly connected to the WG602v4. 

•

Contact NETGEAR if the Wireless LAN light remains off.

Check these items:

•

The WG602v4 is properly installed, LAN connections are OK, and it is powered on. Check 
that the LAN port LED is amber or green to verify that the Ethernet connection is OK. 

•

If you are using the NetBIOS name of the WG602v4 to connect, ensure that your PC and the 
WG602v4 are on the same network segment or that there is a WINS server on your network. 

•

If your PC uses a Fixed (Static) IP address, ensure that it is using an IP Address in the range of 
the WG602v4. The WG602v4 default IP Address is 192.168.0.227 and the default Subnet 
Mask is 255.255.255.0. If you are not sure about these settings, follow the instructions for 

.

There is a configuration problem. Check these items:

•

You may not have restarted the computer with the wireless adapter to have TCP/IP changes 
take effect. Restart the computer.