Netgear RT211 사용자 설명서

Installing and Connecting

2-13

For terminal emulation from a PC, you can use either Microsoft Terminal under Windows 3.1, or 
HyperTerminal under Windows 95. Be sure to set the program for VT100 emulation, including 
arrow keys. Serial port parameters are:

•

9600 bps

•

8 data bits

•

1 stop bit

•

No parity

•

No flow control

The NETGEAR Model RT210 and Model RT211 ISDN routers are shipped with a default IP 
address of 1.1.1.1. If the router configuration is cleared, the IP address reverts to the default 
address. 

To make a Telnet call from a TCP/IP workstation, you must do one of the following:

•

Set your workstation to a spare IP address on network 1.0.0.0 (netmask 255.0.0.0).

•

Add a route to the static routing table of the workstation that indicates that network 1.0.0.0 can 
be reached via the local LAN port.

After the Telnet connection is made, refer to 

When you change the IP address of the router while connected through Telnet, you 

lose the Telnet session. You must then use Telnet to access the new IP address and log in 
again.

NGRRT210.BK  Page 13  Friday, October 17, 1997  2:37 PM