Netgear GS728TPP 사용자 설명서

Select the Disabled radio button to disable DHCP.

Enter the static switch IP address, gateway IP address, and subnet mask for the switch and 

type your password.

You must enter the current password every time you use the Smart 
Control Center to update the switch setting. The default password is 
password.

Click APPLY to configure the switch with the network settings.

Ensure that your computer and the switch are in the same subnet. Make a note of these 
settings for later use.

Configure the Network Settings on the Administrative 
System

If you do not use the Smart Control Center to configure the switch network information, you 
can connect directly to the switch from the administrative system installed on your computer. 
The IP address of the administrative system must be in the same subnet as the default IP 
address on the switch. For most networks, this means you must change the IP address of the 
administrative system to be on the same subnet as the default IP address of the switch 
(192.168.1.1).

To change the IP address on an administrative system running a Windows operating system, 
open the Internet Protocol (TCP/IP) Properties screen that you access from each local area 
connection, as shown in the following screen. You need Windows Administrator privileges to 
change these settings.