Netgear GS728TPP 사용자 설명서
201
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
alternative ways of specifying a match criterion for the same Service Type field in the
IP header; however, each uses a different user notation. After you select the service
type, specify the value associated with the type.
IP header; however, each uses a different user notation. After you select the service
type, specify the value associated with the type.
•
IP DSCP: Specify the IP DiffServ Code Point (DSCP) value. The DSCP is defined
as the high-order 6 bits of the service type octet in the IP header. Select an IP
DSCP value from the list. To specify a numeric value in the available field, select
Other from the list and type an integer from 0 to 63 in the field.
as the high-order 6 bits of the service type octet in the IP header. Select an IP
DSCP value from the list. To specify a numeric value in the available field, select
Other from the list and type an integer from 0 to 63 in the field.
4.
Click ADD.
To modify an existing IP Extended ACL rule, click in the Rule ID field. The number is a
hyperlink to the Extended ACL Rule Configuration screen.
If you modify the rule, click APPLY to submit the changes to the switch.
hyperlink to the Extended ACL Rule Configuration screen.
If you modify the rule, click APPLY to submit the changes to the switch.
IPv6 ACL
An IPv6 ACL consists of a set of rules that are matched sequentially against a packet. When
a packet meets the match criteria of a rule, the specified rule action (permit or deny) is taken,
and the additional rules are not checked for a match. On this screen, the interfaces to which
an IP ACL applies must be specified, as well as whether it applies to inbound or outbound
traffic.
and the additional rules are not checked for a match. On this screen, the interfaces to which
an IP ACL applies must be specified, as well as whether it applies to inbound or outbound
traffic.
To add an IPv6 ACL:
1.
Select Security
ACL, then click the Advanced
IPv6 ACL link.
The following screen displays:
2.
In the IPv6 ACL field, configure the name of IPv6 ACL.
•
The number of the rules associated with the IP ACL is displayed in the Rules field.
•
The ACL type is IPv6 ACL and is displayed in the Type field.