Netgear WNR834B 사용자 설명서
NETGEAR RangeMax™ NEXT Wireless Router WNR834B User Manual
7-2
Troubleshooting
v2.1, July 2007
5. Turn on the computers.
Make sure the Ethernet cables are securely plugged in.
•
The Internet status light on the wireless router will be lit if the Ethernet cable connecting the
wireless router and the modem is plugged in securely and the modem and wireless router are
turned on.
wireless router and the modem is plugged in securely and the modem and wireless router are
turned on.
•
For each powered on computer connected to the wireless router by an Ethernet cable, the
corresponding numbered router LAN port light will be lit.
corresponding numbered router LAN port light will be lit.
Make sure the wireless settings in the computer and router match exactly.
•
For a wirelessly connected computer, the Wireless Network Name (SSID) and WEP or WPA
security settings of the router and wireless computer must match exactly.
security settings of the router and wireless computer must match exactly.
•
If you have enabled the wireless router to restrict wireless access by MAC address, you must
add the wireless computer’s MAC address to the router’s wireless card access list.
add the wireless computer’s MAC address to the router’s wireless card access list.
Make sure the network settings of the computer are correct.
•
Wired and wirelessly connected computers must have network (IP) addresses on the same
network as the router. The simplest way to do this is to configure each computer to obtain an
IP address automatically using DHCP. Please see
network as the router. The simplest way to do this is to configure each computer to obtain an
IP address automatically using DHCP. Please see
or the documentation that came with your computer.
•
Some cable modem service providers require you to use the MAC address of the computer
initially registered on the account. Your wireless router can capture and use that MAC address,
as described in
initially registered on the account. Your wireless router can capture and use that MAC address,
as described in
.
Check the test light to verify correct router operation.
If the Test light does not turn off within 2 minutes after turning the router on, reset the router
according to the instructions in
according to the instructions in
Troubleshooting Basic Functions
After you turn on power to the router, the following sequence of events should occur:
1. When power is first applied, verify that the Power light
is on.
2. After approximately 10 seconds, verify that: