Netgear FVS124G 사용자 설명서

9-6

Troubleshooting

If the path is not working, you see this message:

If the path is not functioning correctly, you could have one of the following problems:

•

Wrong physical connections

— Make sure the LAN port LED is on. If the LED is off, follow the instructions in 

” on 

.

— Check that the corresponding Link LEDs are on for your network interface card and 

for the hub ports (if any) that are connected to your workstation and firewall.

•

Wrong network configuration

— Verify that the Ethernet card driver software and TCP/IP software are both installed 

and configured on your PC or workstation.

— Verify that the IP address for your firewall and your workstation are correct and that 

the addresses are on the same subnet.

After verifying that the LAN path works correctly, test the path from your PC to a remote device. 
From the Windows run menu, type:

PING -n 10 <IP address>

where <IP address> is the IP address of a remote device such as your ISP’s DNS server.

If the path is functioning correctly, replies as in the previous section are displayed. If you do not 
receive replies:

— Check that your PC has the IP address of your firewall listed as the default gateway. If the 

IP configuration of your PC is assigned by DHCP, this information will not be visible in 
your PC’s Network Control Panel. 

— Check to see that the network address of your PC (the portion of the IP address specified 

by the netmask) is different from the network address of the remote device.

— Check that your cable or DSL modem is connected and functioning.

— If your ISP assigned a host name to your PC, enter that host name as the Account Name in 

the Basic Settings menu.