Netgear FVS124G 사용자 설명서

Introduction

2-7

The rear panel of the FVS124G ProSafe VPN Firewall 25 with 4 Gigabit LAN and Dual WAN 
Ports (

) contains the factory defaults reset button, LAN and WAN ports, and DC power 

input connection.

PWR LED

On (Green)
Off

Power is supplied to the firewall.
Power is not supplied to the firewall.

TEST LED

On (Amber)
Blinking (Amber)
Off

Test mode: The system is initializing or the initialization has failed.
Writing to Flash memory (during upgrading or resetting to defaults).
The system has booted successfully.

WAN Port 
LEDs

Link/Act LED

On (Green)
Blinking (Green)
Off

The WAN port has detected a link with a connected Ethernet device.
Data is being transmitted or received by the WAN port.
The WAN port has no link.

100 LED

On (Green)
Off

The WAN port is operating at 100 Mbps.
The WAN port is operating at 10 Mbps.

Active LED

On (Green)
On (Amber)
Off

The WAN port has a valid Internet connection.
The Internet connection is down or not being used.
The WAN port is either not enabled or has no link.

Gigabit LAN 
Port LEDs

Link/Act LED

On (Green)
Blinking (Green)
Off

The LAN port has detected a link with a connected Ethernet device.
Data is being transmitted or received by the LAN port.
The LAN port has no link.

Speed LED

On (Green)
On (Amber)
Off

The LAN port is operating at 1,000 Mbps.
The LAN port is operating at 100 Mbps.
The LAN port is operating at 10 Mbps.