Netgear FVS124G 사용자 설명서

Connecting the FVS124G to the Internet

4-7

1.

Turn off your computer and Cable or DSL Modem.

2.

Disconnect the Ethernet cable from your computer which connects to your cable or DSL 
modem.

3.

Connect the Ethernet cables from your cable or DSL modems to the WAN1 and WAN2 
Internet ports on the FVS124G.

4.

Connect the Ethernet cable which came with the firewall from a Local port on the firewall to 
your computer.

Note: The FVS124G VPN Firewall incorporates Auto Uplink

TM

 technology. Each LOCAL 

Ethernet port will automatically sense if the cable should have a normal connection or an 
uplink connection. This feature eliminates the need to worry about crossover cables because 
Auto Uplink will make the right connection either type of cable.

5.

Now, turn on your computer. If software usually logs you in to your Internet connection, do 
not run that software or cancel it if it starts automatically. 

6.

Verify the following:

•

When your turn the firewall on, the power light goes on.

•

The firewall’s local lights are lit for any computers that are connected to it.

•

The firewall’s Internet light is lit, indicating a link has been established to the cable or 
DSL modem.

See 

 for a description of lights on the front panel and 

their meaning.

Note: To connect to the firewall, your computer needs to be configured to obtain an IP address 
automatically via DHCP. If you need instructions on how to do this, please refer to 

1.

Connect to the firewall by typing 

 in the address field of Internet Explorer or 

Netscape® Navigator.