Netgear fvs114 사용자 설명서
Reference Manual for the ProSafe VPN Firewall FVS114
5-6
Basic Virtual Private Networking
202-10098-01, April 2005
Step 1: Configuring the Client-to-Gateway VPN Tunnel on the
FVS114
FVS114
Follow this procedure to configure a client-to-gateway VPN tunnel using the VPN Wizard.
1.
Log in to the FVS114 at its LAN address of
http://192.168.0.1
with its default user name of
admin and password of password. Click the VPN Wizard link in the main menu to display
this screen. Click Next to proceed.
this screen. Click Next to proceed.
Figure 5-4: VPN Wizard start screen
2.
Fill in the Connection Name and the pre-shared key, select the type of target end point, and
click Next to proceed.
click Next to proceed.
Note: The Connection Name is arbitrary and not relevant to how the configuration functions.
Note:
This section uses the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in
. If you have special requirements not
covered by these VPNC-recommended parameters, refer to