Netgear fvs114 사용자 설명서

5-20

Basic Virtual Private Networking

Follow the procedure below to set the LAN IPs on each FVS114 to different subnets and configure 
each properly for the Internet. 

The LAN IP address ranges of each VPN endpoint must be different. The connection will fail if 
both are using the NETGEAR default address range of 192.168.0.x. 

In this example, LAN A uses 192.168.0.1 and LAN B uses 192.168.3.1.

This section uses the VPN Wizard to set up the VPN tunnel using the VPNC 

default parameters listed in 

. If you have special requirements not 

covered by these VPNC-recommended parameters, refer to 

VPN Tunnel