Netgear D7000 사용자 설명서

In the Enter Client's PIN field, enter the PIN number of the WiFi device.

Click the Next button.

For four minutes, the modem router attempts to find the WiFi device (that is, the client) that you want
to join the modem router’s main WiFi network.

During this time, the WiFi LED on the top panel of the modem router blinks white.

Within four minutes, go to the WiFi device and use its WPS software to join the network without entering
a password.

When the modem router establishes a WPS connection, the WiFi LED lights solid white and the Add
WPS Client page displays a confirmation message.

To verify that the WiFi device is connected to the modem router’s main WiFi network, select BASIC
> Attached Device.

The WiFi device displays onscreen.

A guest network allows visitors to use the Internet without using your WiFi security key. By default, the
guest WiFi network is disabled. You can enable and configure the guest WiFi network for each WiFi band.
The modem router simultaneously supports the 2.4 GHz band for 802.11n, 802.11g, and 802.11b devices
and the 5 GHz band for 802.11ac, 802.11na, and 802.11a devices.

The WiFi mode of the guest WiFi network depends on the WiFi mode of the main WiFi network. For
example, if you configure the WiFi mode for the main WiFi network as Up to 54 Mbps in the 2.4 GHz band,
the guest WiFi network also functions in the Up to 54 Mbps mode in the 2.4 GHz band. For information
about configuring the WiFi mode, see 

 on page 102.

The modem router provides two default guest networks with the following names (SSIDs):

2.4 GHz band. NETGEAR_Guest1

5 GHz band. NETGEAR-5G_Guest1

By default, these networks are configured as open networks without security but are disabled. You can
enable one or both networks. You can also change the SSIDs for these networks.