Netgear CG814M 사용자 설명서

C-4

Preparing Your Network

If you need Client for Microsoft Networks:

a.

Click the Add button.

b.

Select Client, and then click Add.

c.

Select Microsoft.

d.

Select Client for Microsoft Networks, and then click OK.

3.

Restart your PC for the changes to take effect.

After the TCP/IP protocol components are installed, each PC must be assigned specific 
information about itself and resources that are available on its network. The simplest way to 
configure this information is to allow the PC to obtain the information from the internal DHCP 
server of the CG814M Gateway. To use DHCP with the recommended default addresses, follow 
these steps:

1.

Connect all PCs to the gateway, then restart the gateway and allow it to boot.

2.

On each attached PC, open the Network control panel (refer to the previous section) and select 
the Configuration tab.

3.

From the components list, select TCP/IP->(your Ethernet adapter) and click Properties.

4.

In the IP Address tab, select “Obtain an IP address automatically”.

5.

Select the Gateway tab.

6.

If any gateways are shown, remove them.

7.

Click OK.

8.

Restart the PC.

Repeat steps 2 through 8 for each PC on your network.

1.

On the Windows taskbar, click the Start button, point to Settings, and then click Control Panel.

2.

Double-click the Internet Options icon.

3.

Select “I want to set up my Internet connection manually” or “I want to connect through a 
Local Area Network” and click Next.

4.

Select “I want to connect through a Local Area Network” and click Next.