NEC NWA-008869-001 사용자 설명서
CHAPTER 5 EXAMPLES OF SETUP ON NETWORKS
– 129 –
NWA-008869-001 Rev.1.0
atch5001.fm
Setting for router B
Setting the route
As the default route, use Serial0.0. Perform this on both routers A and B.
As the default route, use Serial0.0. Perform this on both routers A and B.
Setting DTI card
When originating a call from legacy terminal (single line telephone/D
When originating a call from legacy terminal (single line telephone/D
term
) to a digital private network (T1)
via PZ-M649 card, the PN-24DTA-C (DTI) card is required. For the setting of DTI card, do the office data
programming for Direct Digital Interface (Refer to the Feature Programming Manual).
programming for Direct Digital Interface (Refer to the Feature Programming Manual).
NOTE:
The time slot number of both PN-RTA card side (PZ-M649 card) and PN-24DTA-C card side
have to be the same. Therefore, in the office data programming for Direct Digital Interface, as-
sign the same time slot number as PN-RTA card side by using CM07 Y=01.
For example, if the time slot number of PN-RTA card side is default setting (12 to 23), specify
12 to 23 for the channel number of PN-24DTA-C card in the data assignment of CM07 Y=01.
have to be the same. Therefore, in the office data programming for Direct Digital Interface, as-
sign the same time slot number as PN-RTA card side by using CM07 Y=01.
For example, if the time slot number of PN-RTA card side is default setting (12 to 23), specify
12 to 23 for the channel number of PN-24DTA-C card in the data assignment of CM07 Y=01.
Router # enable
− config
Router (config) # ppp profile router
− b
Router (config
− ppp − router − b) # no ipcp request − local − dns
Router (config
− ppp − router − b) # exit
Router (config) # interface FastEthernet0.0
Router (config
− FastEthernet0.0) # ip address 192.168.2.1/24
Router (config
− FastEthernet0.0) # no shutdown
Router (config
− FastEthernet0.0) # interface Serial0.0
Router (config
− Serial0.0) # ppp binding router − b
Router (config
− Serial0.0) # ip unnumbered FastEthernet0.0
Router (config
− Serial0.0) # no shutdown
Router (config
− Serial0.0) #
Enter
Enter
Enter
Enter
Enter
Enter
Enter
Enter
Enter
Enter
Enter
Router (config
− FastEthernet0.0) # exit
Router (config) # ip route default Serial0.0
Router (config) #
Enter
Enter
DIGITAL PRIVATE LINE NETWORK EXAMPLE (T1)