Netgear D6300 사용자 설명서

Wireless Repeater. The WiFi modem router sends all traffic from its local wireless or wired 
computers to a remote access point. To configure this mode, you have to know the MAC 
address of the remote parent access point. 

The D6300 WiFi modem router is always in dual-band concurrent mode, unless you turn off 
one radio. If you enable the wireless repeater in either radio band, the wireless base station 
or wireless repeater cannot be enabled in the other radio band. However, if you enable the 
wireless base station in either radio band and use the other radio band as a wireless WiFi 
modem router or wireless base station, dual-band concurrent mode is not affected.

For you to set up a wireless network with WDS, 

t

he following conditions have to be met for 

both access points:

Both access points have to use the same SSID, wireless channel, and encryption mode.

Both access points have to be on the same LAN IP subnet. That is, all the access point 
LAN IP addresses are in the same network.

All LAN devices (wired and wireless computers) have to be configured to operate in the 
same LAN network address range as the access points.

Wireless Repeating Function 

Select ADVANCED > Advanced Setup > Wireless Repeating Function to view or change 
wireless repeater settings for the WiFi modem router.

Enable Wireless Repeating Function. Select the check box for the 2.4-GHz or 5-GHz 
network to use the wireless repeating function.

Disable Wireless Client Association. If your WiFi modem router is the repeater, 
selecting this check box means that wireless clients cannot associate with it. Only LAN 
client associations are allowed.

If you are setting up a point-to-point bridge, select this check box.