Netgear D6300 사용자 설명서



From the Windows toolbar, click Start, and then select Run.

In the field provided, type ping followed by the IP address of the WiFi modem router, as in 

this example:

Click OK.

You should see a message like this one:

If the path is working, you see this message:

If the path is not working, you see this message:

If the path is not functioning correctly, you could have one of the following problems:

Wrong physical connections

For a wired connection, make sure that the numbered LAN port LED is lit for the port to 
which you are connected.

Check that the appropriate LEDs are lit for your network devices. If your WiFi modem 
router and computer are connected to a separate Ethernet switch, make sure that the 
Ethernet LEDs are lit for the switch ports that are connected to your computer and WiFi 
modem router.

Wrong network configuration

Verify that the Ethernet card driver software and TCP/IP software are both installed and 
configured on your computer. 

Verify that the IP address for your WiFi modem router and your computer are correct and 
that the addresses are on the same subnet.

Test the Path from Your Computer to a Remote Device

After verifying that the LAN path works correctly, test the path from your computer to a remote 
device.

From the Windows toolbar, click the Start button, and then select Run.

In the Windows Run window, type:

ping -n 10 <IP address>

where <IP address> is the IP address of a remote device such as your ISP’s DNS server.

If the path is functioning correctly, replies like the examples shown in the previous section are 
displayed.