Netgear CG814WG 사용자 설명서

C-10

Configuring Wireless Security in Windows XP

If you have problems connected to your wireless network, try the tips below.

Also, for problems with accessing network resources, the Windows software might not be installed 
and configured properly on your computers. Please refer to Windows documentation for 
instructions on these options.

The PC Card 
LINK LED is 
not lit.

The wireless 
adapter is not 
inserted into the 
slot properly or its 
software is not 
loaded. 

Remove and reinsert the wireless adapter.
Check the Windows device manager to see if the PC 
Card is recognized and enabled. Reload the wireless 
adapter software, if necessary.
Try to install the wireless adapter in a different 
CardBus slot on your system if one is available.

The LINK LED 
is blinking 
repeatedly. 

The wireless 
adapter is 
attempting to 
connect to access 
point but cannot 
connect. 

The access point may not be powered on. Or, the 
access point and the PC card are not configured with 
the same wireless parameters. Check the SSID and 
WEP settings.

I can connect to 
an access point, 
but I cannot 
connect to other 
computers on 
the network or 
the Internet.

This could be a 
physical layer 
problem or a 
network 
configuration 
problem.

Check to make sure that the access point is physically 
connected to the Ethernet network.

Make sure that the IP addresses and the Windows 
networking parameters are all configured correctly.

Restart the cable or DSL modem, router, access point, 
and notebook PC.