Netgear CVG824G 사용자 설명서

4-4

Managing Your Network

The gateway is preconfigured to use private IP addresses on the LAN side, and to act as a DHCP 
server. The LAN IP settings are explained below:

•

LAN IP address: This is the IP address of the gateway.

 

The default is 192.168.0.1.

•

Subnet mask: This is the LAN subnet mask of the gateway. The default is 255.255.255.0. 
Combined with the IP address, the subnet mask allows a device to know which other addresses 
are local to it, and which must be reached through a gateway or router.

These addresses are part of the IETF-designated private address range for use in private 
networks, and should be suitable in most applications. If your network has a requirement to 
use a different IP addressing scheme, you can make those changes in the LAN IP page.

•

DHCP Server: By default, the gateway is a Dynamic Host Configuration Protocol (DHCP) 
server. See 

•

Starting Address and Ending Address: Specify the pool of IP addresses to be assigned by 
setting the Starting IP Address and Ending IP Address. These addresses should be part of the 
same IP address subnet as the gateway’s LAN IP address. Using the default addressing 
scheme, you should define a range between 192.168.0.10 and 192.168.0.253. The range of IP 
addresses between 192.168.0.2 and 192.168.0.9 can be used for devices with fixed (or static) 
addresses.

•

DHCP Reservation Lease Info: View information about each PC that has been assigned a 
DHCP lease by the gateway. The MAC address of the PC, IP address assigned and the 
expiration time of the DHCP lease are listed. You can manually revoke the DHCP leases by 
clicking Clear DHCP Leases.

Note: If you change the LAN IP address of the gateway while connected through the 

browser, you will be disconnected. You must then open a new connection to 
the new IP address and log in again