Netgear WNDR3700-100NAS 사용자 설명서
RangeMax™ Dual Band Wireless-N Gigabit Router WNDR3700 User Manual
Troubleshooting
8-14
v1.3, October 2009
Restoring the Default Configuration and Password
This section explains how to restore the factory default configuration settings, changing the
router’s administration password back to password. You can erase the current configuration and
restore factory defaults in two ways:
router’s administration password back to password. You can erase the current configuration and
restore factory defaults in two ways:
•
).
•
Use the Reset button on the bottom of the router. Use this method for cases when the
administration password or IP address is not known.
administration password or IP address is not known.
To restore the factory default configuration settings when you do not know the administration
password or IP address, you must use the restore settings button on the bottom of the router.
password or IP address, you must use the restore settings button on the bottom of the router.
1. Press and hold the restore settings button for over 5 seconds until the Power light turns to
blinking amber.
2. Release the restore settings button, and wait for the router to reboot.
If the wireless router fails to restart, or the green Power light continues to blink, the unit might be
defective. If the error persists, you might have a hardware problem and should contact Technical
Support at
defective. If the error persists, you might have a hardware problem and should contact Technical
Support at
.