Netgear WNDR3700-100NAS 사용자 설명서

Safeguarding Your Network

2-18

You can add more WPS clients to your wireless network, or you can add a combination of WPS-
enabled clients and clients without WPS.

To add a wireless client device that is WPS-enabled:

1. Follow the procedures in 

2. To view a list of all devices connected to your wireless router (including wireless and 

.

For non-WPS clients, you cannot use the WPS setup procedures to add them to the wireless 
network. You must record, and then manually enter your security settings (see 

).

To connect a combination of non-WPS enabled and WPS-Enabled clients to the wireless router:

1. Restore the wireless router to its factory default settings (press both the Wireless and WPS 

buttons on the side of the wireless router for 5 seconds).

When the factory settings are restored, all existing wireless clients are disassociated and 
disconnected from the wireless router.

2. Configure the network names (SSIDs), select the WPA/PSK + WPA2/PSK radio button on the 

Wireless Settings screen (see 

and click Apply. On the WPA/PSK + WPA2/PSK screen, select a passphrase and click Apply. 
Record this information to add additional clients.

Note: Your wireless settings remain the same when you add another WPS-enabled client, 

as long as the Keep Existing Wireless Settings check box is selected in the 
Advanced Wireless screen (listed under the Advanced heading in the wireless 
router main menu). If you clear this check box, when you add the client, a new 
SSID and passphrase will be generated, and all existing connected wireless clients 
will be disassociated and disconnected from the wireless router.