Netgear FVS318v3 사용자 설명서

Advanced Virtual Private Networking

6-21

You can test connectivity and view VPN status information on the FVS318v3 (see also 

).

1.

Using our example, from a PC attached to the FVS318v3 on LAN A, on a Windows PC click 
the Start button on the taskbar and then click Run.

2.

Type  ping -t  172.23.9.1, and then click OK.

3.

This will cause a continuous ping to be sent to the LAN interface of Gateway B. Within two 
minutes, the ping response should change from timed out to reply.

4.

At this point the connection is established. 

5.

To test connectivity between the FVS318v3 Gateway A and Gateway B WAN ports, follow 
these steps:

a.

Using our example, log in to the FVS318v3 on LAN A, go to the main menu Maintenance 
section and click the Diagnostics link.

b.

To test connectivity to the WAN port of Gateway B, enter  22.23.24.25, and then click 
Ping.

c.

This causes a ping to be sent to the WAN interface of Gateway B. Within two minutes, the 
ping response should change from timed out to reply. You may have to run this test several 
times before you get the reply message back from the target FVS318v3. 

d.

At this point the connection is established. 

Note: If you want to ping the FVS318v3 as a test of network connectivity, be sure the 
FVS318v3 is configured to respond to a ping on the Internet WAN port by checking the check 
box seen in 

 on 

. However, to preserve a high degree of security, you should 

turn off this feature when you are finished with testing.

6.

To view the FVS318v3 event log and status of Security Associations, follow these steps:

a.

Go to the FVS318v3 main menu VPN section and click the VPN Status link.

b.

The log screen displays a history of the VPN connections, and the IPSec SA and IKE SA 
tables will report the status and data transmission statistics of the VPN tunnels for each 
policy.