Netgear D6200-100NAS 사용자 설명서

Wireless repeater. The WiFi DSL modem router sends all traffic from its local wireless or 
wired computers to a remote access point. To configure this mode, you have to know the 
MAC address of the remote parent access point. 

The D6200 WiFi DSL modem router is always in dual-band concurrent mode, unless you turn 
off one radio. If you enable the wireless repeater in either radio band, the wireless base 
station or wireless repeater cannot be enabled in the other radio band. However, if you 
enable the wireless base station in either radio band and use the other radio band as a 
wireless WiFi DSL modem router or wireless base station, dual-band concurrent mode is not 
affected.

For you to set up a wireless network with WDS, 

t

he following conditions have to be met for 

both access points:

Both access points have to use the same SSID, wireless channel, and encryption mode.

Both access points have to be on the same LAN IP subnet. That is, all the access point 
LAN IP addresses are in the same network.

All LAN devices (wired and wireless computers) have to be configured to operate in the 
same LAN network address range as the access points.

Wireless Repeating Function

Use the Wireless Repeating Function screen to view or change the wireless repeater 
settings.



Select ADVANCED > Advanced Setup > Wireless Repeating Function.

Configure the following settings: