Netgear D500 and D1500 사용자 설명서

Click the Apply button.

Your settings are saved.

Click the Test button to test your Internet connection. 

If you want to manually configure the Internet connection settings, use the information that 
your ISP gave you to log in to your Internet service. If you cannot find this information, 
contact your ISP. 

Use IP over ATM (IPoA)

Enter the IP address, IP subnet mask, and the gateway IP address that 
your ISP assigned for IPoA service. The gateway is the ISP router to which 
your modem router connects.

The DNS server is used to look up site addresses based on their names. 

Get Dynamically from ISP

Your ISP uses DHCP to assign your DNS servers. Your ISP automatically 
assigns this address.

Use These DNS Servers

If you know that your ISP does not automatically transmit DNS addresses 
to the modem router during login, select this option and enter the IP 
address of your ISP primary DNS server. If a secondary DNS server 
address is available, enter it also.

The Ethernet MAC address that the modem router uses on the Internet port. Some ISPs register the MAC 
address of the network interface card in your computer when your account is first opened. They accept 
traffic only from the MAC address of that computer. This feature allows your modem router to use your 
computer’s MAC address (also called cloning). 

Use Default Address

Use the default MAC address.

Use Computer MAC Address

The modem router captures and uses the MAC address of the computer 
that you are now using. You must use the one computer that is allowed by 
the ISP.

Use This MAC Address

Enter the MAC address that you want to use.

NAT allows computers on your home network to share the modem router Internet connection. NAT is 
enabled by default because it is needed in most situations. To specify the NAT setting, select one of the 
following radio buttons:

Enable. NAT is enabled. This is the default setting.

Disable. NAT is disabled.