Netgear DG834GUV5 사용자 설명서

2-2

Configuring Your Wireless Network and Security Settings

–

Wireless security option. To successfully implement wireless security, check each wireless 
adapter to determine which wireless security option it supports. 

.

•

Push 'N' Connect (WPS) automatically implements wireless security on the modem router 
while, at the same time, allowing you to automatically implement wireless security on any 
WPS-enabled devices (such as wireless computers and wireless adapter cards). You activate 
WPS by pressing a WPS button on the modem router, clicking an onscreen WPS button, or 
entering a PIN number. This generates a new SSID and implements WPA/WPA2 security.

To set up your wireless network using the WPS feature:

–

Use the WPS button on the side of the modem router (there is also an onscreen WPS 
button ), or enter the PIN of the wireless device. 

–

Make sure that all wireless computers and wireless adapters on the network are 

Wi-Fi 

certified and WPA or WPA 2 capable, and that they support WPS configuration.

.

The range of your wireless connection can vary significantly based on the physical placement of 
the modem router. The latency, data throughput performance, and notebook power consumption of 
wireless adapters also vary depending on your configuration choices.

For best results, place your modem router according to the following guidelines:

•

Near the center of the area in which your PCs will operate.

•

In an elevated location such as a high shelf where the wirelessly connected PCs have line-of-
sight access (even if through walls).

•

Away from sources of interference, such as PCs, microwave ovens, and 2.4 GHz cordless 
phones.

•

Away from large metal surfaces.

•

Put the antenna in a vertical position to provide the best side-to-side coverage. Put the antenna 
in a horizontal position to provide the best up-and-down coverage. 

•

If using multiple access points, it is better if adjacent access points use different radio 
frequency channels to reduce interference. The recommended channel spacing between 
adjacent access points is 5 channels (for example, use Channels 1 and 6, or 6 and 11).