EnGenius Technologies EVR100 사용자 설명서
60
Advanced
Fragment Threshold
Specifies the size of the packet per fragment. This function can reduce the chance of packet
collision.
However when this value is set too low, there will be increased overheads resulting in poor
performance.
collision.
However when this value is set too low, there will be increased overheads resulting in poor
performance.
RTS Threshold
When the packet size is smaller than the RTS Threshold, then the packet will be sent without
RTS/CTS handshake which may result in incorrect transmission.
RTS/CTS handshake which may result in incorrect transmission.
Beacon Interval
The time interval that the device broadcasts a beacon. This beacon is used to synchronize all
wireless clients on the network.
wireless clients on the network.
DTIM Period
A Delivery Traffic Indication Message informs all wireless clients that the access point will be
sending Multi-casted data.
sending Multi-casted data.
N Data Rate
You can limit the transfer rates between the device and wireless clients. Each Modulation Coding
Scheme (MCS) refers to a specific transfer speed.
Scheme (MCS) refers to a specific transfer speed.
Channel Bandwidth
Set whether each channel uses 20 or 40Mhz.
To achieve 11n speeds, 40Mhz channels must be used.
To achieve 11n speeds, 40Mhz channels must be used.
Preamble Type
A preamble is a message that helps access points synchronize with the client.
Long Preamble is standard based so increases compatibility.
Short Preamble is non-standard, so it decreases compatibility but increases performance.
Long Preamble is standard based so increases compatibility.
Short Preamble is non-standard, so it decreases compatibility but increases performance.
CTS Protection
When Enabled, the performance is slightly lower however the chances of packet collision is
greatly reduced.
greatly reduced.
Tx Power
Set the power output of the wireless signal.