Fortinet 500A 사용자 설명서
28
01-28005-0101-20041015
Fortinet Inc.
Configuring basic settings
NAT/Route mode installation
To add a default route
Add a default route to configure where the FortiGate unit sends traffic destined for an
external network (usually the Internet). Adding the default route also defines which
interface is connected to an external network. The default route is not required if the
interface connected to the external network is configured using DHCP or PPPoE.
external network (usually the Internet). Adding the default route also defines which
interface is connected to an external network. The default route is not required if the
interface connected to the external network is configured using DHCP or PPPoE.
1
Go to System > Router > Static.
2
If the Static Route table contains a default route (IP and Mask set to 0.0.0.0), select
the Delete icon to delete this route.
the Delete icon to delete this route.
3
Select Create New.
4
Set Destination IP to 0.0.0.0.
5
Set Mask to 0.0.0.0.
6
Set Gateway to the default gateway IP address.
7
Set Device to the interface connected to the external network.
8
Select OK.
Using the front control buttons and LCD
Basic settings, including interface IP addresses,
netmasks, default gateways, and the FortiGate
operating mode can be configured using the LCD
and front control buttons on the FortiGate unit. Use
the information that you recorded in
netmasks, default gateways, and the FortiGate
operating mode can be configured using the LCD
and front control buttons on the FortiGate unit. Use
the information that you recorded in
Table 5 on
page 26
to complete the following procedure. Start when Main Menu is displayed on
the LCD.
To change the IP address and netmask of an interface
1
Press Enter to display the interface list.
2
Use the up and down arrows to highlight the name of the interface to change and
press Enter.
press Enter.
3
Press Enter for IP address.
4
Use the up and down arrow keys to increase or decrease the value of each IP address
digit. Press Enter to move to the next digit. Press Esc to move to the previous digit.
digit. Press Enter to move to the next digit. Press Esc to move to the previous digit.
5
After you set the last digit of the IP address, press Enter.
6
Use the down arrow to highlight Netmask.
7
Press Enter and change the Netmask.
8
After you set the last digit of the Netmask, press Enter.
9
Press Esc to return to the Main Menu.
Note: When you enter an IP address, the LCD always shows three digits for each part of the
address. For example, the IP address 192.168.100.1 appears on the LCD as 192.168.100.001.
The IP address 192.168.23.45 appears as 192.168.023.045.
address. For example, the IP address 192.168.100.1 appears on the LCD as 192.168.100.001.
The IP address 192.168.23.45 appears as 192.168.023.045.