Proxim 70443r2 사용자 설명서

10

2.  Connect the PC to the Master unit; start the Manager program by clicking on the QuickBridge Manager 

icon.  You can connect to the Slave unit as well; however, this guide steps you through the initialization 
process by locally connecting to the Primary.  

Note:  The QuickBridge Manager program can run on two PCs connected to both ends of the link without 

interfering with one another.  

3.  Apply power to both units by connecting the AC cord of the Power & Ethernet Adapters to an AC outlet.  

After power is applied and a power-up sequence has been successfully completed, the radios each “chirp” 
once. 

When selecting a location in which to install the radios, keep the following points in mind: 

•  Determine the direction to the radio 

•  Avoid obstructions and foliage that could block the signal 

•  Place the power & Ethernet adapter in a weatherproof enclosure near the radio or inside the building. 

If necessary, disconnect the cables you used to configure the radios inside, move the radios to their outdoor 
locations, and then connect them to the network segments you want to bridge. 

After you connect each radio to its network segment, make sure you install the configuration software on the two 
PCs used to control the radios (one PC per radio).  Use the configuration software to assign each radio a valid 
and unique IP address for the network segment to which it is attached. 

Be sure to properly weatherproof outdoor connections.  See “Weatherproofing Connections” in Tsunami 
QuickBridge II T1/E1 Installation and Management. 

When not using GPS, or when GPS is disabled, do not co-locate two hops on the same 
side of the building or on the same pole.