Trendnet TEW-812DRU 사용자 설명서

다운로드
페이지 66
 
 
 
 
 
 
 
 
 
 
© Copyright 2013 TRENDnet. All Rights Reserved. 
 
 
 
 
TRENDnet User’s Guide
 
TEW-812DRU 
30
 
 
3. In LAN Interface Setting section enter the Internal Network section review the below 
settings to apply. 
•  IP Address: Enter the new router IP address.  (e.g. 192.168.200.1
•  Subnet Mask: Enter the new router subnet mask.  (e.g. 255.255.255.0
Note: The DHCP address range will change automatically to your new router IP 
address settings so you do not have to change the DHCP address range manually 
to match your new router IP address settings.  
4. To save changes, click Apply
Note: You will need to access your router management page using your new 
router IP address to access the router management page. (e.g. Instead of using 
the defaul
 using your new router IP address will use the 
following format using your new router IP address 
http://(new.router.ipaddress.here) to access your router management page. 
 
 
Set up the DHCP server on your router 
Network > LAN Setting  
Your router can be used as a DHCP (Dynamic Host Configuration Protocol) server to 
automatically assign an IP address to each computer or device on your network. The 
DHCP server is enabled by default on your router. If you already have a DHCP server on 
your network, or if you do not want to use your router as a DHCP server, you can disable 
this setting. It is recommended to leave this setting enabled. 
 
1. Log into your router management page (see “
 
on page 26). 
 
2. Click on Network, and click on LAN Setting
 
 
3. In Internal Network section review the below settings. Click Apply to save settings. 
•  DHCP Server: Enable or Disable the DHCP server. 
•  Start IP: Changes the starting address for the DHCP server range. 
(e.g.192.168.10.20) 
•  End IP: Changes the last address for the DHCP server range. (e.g. 192.168.10.30) 
Note: The Start IP and End IP specify the range of IP addresses to automatically 
assign to computers or devices on your network. 
•  DHCP Lease Time – Click the drop-down list to select the lease time.  
Note: The DHCP lease time is the amount of time a computer or device can keep 
an IP address assigned by the DHCP server. When the lease time expires, the 
computer or device will renew the IP address lease with the DHCP server, 
otherwise, if there is no attempt to renew the lease, the DHCP server will 
reallocate the IP address to be assigned to another computer or device.