Avaya CMC1 사용자 설명서

3. Press Enter to submit the schedule. 

If you set the 

Schedule

 

Download

 field to n, the download starts as soon as you submit 

the schedule.

Note:

If you are scheduling firmware downloads for a circuit pack that is designated as 
primary/secondary sync (timing) source (for example, TN464GP/HP), this 
procedure automatically redesignates a local timing source during the download. 
After the download is complete and the circuit pack is returned to service, the 
procedure designates the original circuit pack as the timing source.

Note:

The target circuit packs are automatically removed from service while the 
firmware is downloaded to them and automatically returned to service after the 
download is completed. While a circuit pack is removed from service, any active 
calls through that circuit pack are dropped.

Note:

An error message asking you to use the command, test firmware download, 
means that there was a problem with a previous firmware download. Run the test 
before proceeding. Go to 

CAUTION:

Unless the 

Remove Image File After Successful Download 

field is set 

to 

, the ftplogin and ftppassword remain on the TN799DP or TN799C (C-LAN) 

and TN2501AP (VAL) circuit packs either until they are reset or until you type the 
disable filesystem board UUCSS command.

4. If the download is scheduled for later, ensure that the download will run as you intend by 

testing the firmware download. Go to 

Check the progress of a firmware download with the following procedure.