ZyXEL Communications NBG-416N 사용자 설명서
Chapter 4 Modes
NBG-416N User’s Guide
48
5
Go to Maintenance > Sys OP Mode > General and select Access Point.
Figure 30 Maintenance > Sys OP Mode > AP
6
A pop-up window appears providing information on this mode. Click OK in the
pop-up message window. Click Apply. Your NBG-416N is now in AP Mode.
pop-up message window. Click Apply. Your NBG-416N is now in AP Mode.
Note: Wait while the NBG-416N restarts, then log in to the Web Configurator again.
4.3.1 Status Screen (AP Mode)
Click on Status. The screen below shows the status screen in AP Mode.
Figure 31 Status Screen (AP Mode)
The following table describes the labels shown in the Status screen.
Table 20 Status Screen (AP Mode)
LABEL
DESCRIPTION
Device Information
System Name
This is the System Name you enter in the Maintenance >
System > General screen. It is for identification purposes.
System > General screen. It is for identification purposes.