Draytek 2130 사용자 설명서
Vigor2130 Series User’s Guide
100
4
4
.
.
1
1
.
.
2
2
P
P
o
o
r
r
t
t
s
s
Ports page is used to change the setting for WAN port. You can set or reset the following
items. All of them are described in detail below.
items. All of them are described in detail below.
Port
It displays current network interface.
Link
It displays current connection status. Green light means the
WAN connection is successful.
WAN connection is successful.
Current
It displays current speed that the router uses.
Speed Configured
You can use the drop down list to choose the required speed for
the router. If you have no idea in configuring speed, simple use
the default setting, Auto.
the router. If you have no idea in configuring speed, simple use
the default setting, Auto.
Flow Control
If flow control is enabled by checking Configured box, both
parties can send PAUSE frame to the transmitting device(s) if
the receiving port is too busy to handle. If not, there will be no
flow control in the port. It drops the packet if too much to
handle.
Current Rx: indicates whether pause frames on the port are
obeyed.
Current Tx: indicates whether pause frames on the port are
transmitted.
parties can send PAUSE frame to the transmitting device(s) if
the receiving port is too busy to handle. If not, there will be no
flow control in the port. It drops the packet if too much to
handle.
Current Rx: indicates whether pause frames on the port are
obeyed.
Current Tx: indicates whether pause frames on the port are
transmitted.
Maximum Frame
This module offers 1518~9600 (Bytes) length to make the long
packet for data transmission.
packet for data transmission.
Excessive Collision Mode
There are two modes for you to choose when excessive
collision happened in half-duplex condition.
collision happened in half-duplex condition.