ZyXEL Communications GS-1524 사용자 설명서

Chapter 4 The Web Configurator

GS-1524/GS-1548 User’s Guide

After you log in for the first time, it is recommended you change the default administrator 
password. Click  System, Password to display the next screen. 

Mirror

Use this screen to copy traffic from one port or ports to another port in order that 

you can examine the traffic from the first port without interference.

QoS

Use these screens to configure queuing with associated queue weights for the 

Switch.

Rate

Use these screens to specify bandwidth limits and storm control limits for the 

Switch.

Port Rate

Use this screen to cap the maximum bandwidth allowed from specified source(s) to 

specified destination(s).

Storm 

Control

Use this screen to cap the rate of broadcast, multicast and unknown unicast 

packets the Switch will allow on individual ports.

L2 Address

Use these screens to view and manage the MAC address table.

Management Use this screen to add, delete or look up MAC addresses in the MAC address 

table.

Display

Use this screen to view the entries in the MAC address table.

Cable Diagnostic Use this screen to perform cable testing on individual ports.

Auto DoS

Use these screens to activate security features against Denial of Service (DoS) 

attacks.

Auto VoIP

Use these screens to configure settings that automatically give higher priority to 

Voice over Internet Protocol (VoIP) traffic.

Logging

Use these screens to configure log settings and view system logs.

Settings

Use this screen to configure which events the Switch should log.

RAM Logs

Use this screen to configure logs which are saved to volatile memory. These logs 

are cleared when the Switch is rebooted.

Flash Logs

Use this screen to configure logs which are saved to non-volatile memory. These 

logs can be seen even after the Switch is rebooted.

SNMP

Use these screens to configure SNMP management settings.

Engine ID

Use this screen to configure SNMP engine ID.

Group

Use this screen to configure groups with different access rights for SNMP 

management. 

User

Use this screen to create users and assign them to pre-defined SNMP groups.

Community

Use this screen to define security parameters for SNMP v1 and SNMP v2c.

Trap Station

Use this screen to configure settings that define when notifications are sent to an 

external management station.

RMON-Lite

Use this screen to configure Remote Network Monitoring Management Information 

Base (RMON MIB) settings.

Dynamic ARP

Use these screens to enable and configure ARP table settings.

Settings

Use this screen to configure ARP table settings.

ARP Entries

Use this screen to enter and view MAC address to IP address mappings.

Logout

Click this to logout of the web configurator.

Table 4   Navigation Panel Links  (continued)