ZyXEL Communications Wireless Gateway Series 사용자 설명서

ZyAIR Wireless Gateway Series User’s Guide 
 

16-8 

 

Maintenance 

 

 

 

Channel 

 

This is the index number of the channel currently used by the associated AP in an 
Infrastructure wireless network or wireless station in an Ad-Hoc wireless network.

 

Signal 

This field displays the strength of the AP’s signal. If you must choose a channel that’s 
currently in use, choose one with low signal strength for minimum interference. 

Network 
Mode 

“Network mode” in this screen refers to your wireless LAN infrastructure (refer to the Wireless 
LAN chapter) and WEP setup.  
Network modes are: Infrastructure (same as an extended service set ESS)), Infrastructure 
with WEP (WEP encryption is enabled), Ad-Hoc (same as an independent basic service set 
IBSS)), or Ad-Hoc with WEP. 

Refresh 

Click Refresh to reload the screen.  

Find firmware at 

www.zyxel.com

 in a file that (usually) uses the system model name with a "*.bin" 

extension, e.g., "zyair.bin". The upload process uses HTTP (Hypertext Transfer Protocol) and may take up to 
two minutes. After a successful upload, the system will reboot.  See the Firmware and Configuration File 
Maintenance chapter for upgrading firmware using FTP/TFTP commands. 
Click MAINTENANCE, and then the F/W Upload tab. Follow the instructions in this screen to upload 
firmware to your ZyAIR.  

 

The following table describes the labels in this screen.