ZyXEL Communications 1001H 사용자 설명서
P100IH ISDN Router
2-8
Hardware Installation and Setup
ZyNOS firmware file (sometimes referred to as the “ras” file) is the file that contains the ZyXEL Network
Operating System firmware and the external firmware file is usually called the router model name with a
*.bin extension, e.g., P100IH.bin. Rename the configuration filename to “rom-0” and the firmware filename
to “ras” when transferring files to the Prestige (i.e., the internal filenames on the Prestige). Renaming the
files is not necessary when you transfer files to the Prestige using the X-Modem protocol.
Operating System firmware and the external firmware file is usually called the router model name with a
*.bin extension, e.g., P100IH.bin. Rename the configuration filename to “rom-0” and the firmware filename
to “ras” when transferring files to the Prestige (i.e., the internal filenames on the Prestige). Renaming the
files is not necessary when you transfer files to the Prestige using the X-Modem protocol.
2.7.1
Resetting the Prestige
If you have forgotten your password or for some reason cannot access the SMT menu you will need to
reinstall the configuration file. Uploading the configuration file replaces the current configuration file with
the default configuration file, you will lose all configurations that you had before and the speed of the
console port will be reset to the default of 9600bps with 8 data bit, no parity and 1 stop bit (8n1). The
password will be reset to the default of 1234, also.
reinstall the configuration file. Uploading the configuration file replaces the current configuration file with
the default configuration file, you will lose all configurations that you had before and the speed of the
console port will be reset to the default of 9600bps with 8 data bit, no parity and 1 stop bit (8n1). The
password will be reset to the default of 1234, also.
Turn off the Prestige and begin a Telnet session with the default console port settings. Turn on the Prestige
again. When you see the message "Press Any key to enter Debug Mode within 3 seconds", press any key to
enter debug mode. You should already have downloaded the correct file from your nearest ZyXEL FTP
site.
again. When you see the message "Press Any key to enter Debug Mode within 3 seconds", press any key to
enter debug mode. You should already have downloaded the correct file from your nearest ZyXEL FTP
site.
2.8 General
Setup
Menu 1 - General Setup
contains administrative and system-related information.
To enter Menu 1 and fill in the required information, follow these steps:
Step 1.
Enter 1 in the Main Menu to open Menu 1 – General Setup.
Step 2.
The Menu 1 - General Setup screen appears, as shown below. Fill in the required fields marked
[?] as shown in the following table.
[?] as shown in the following table.
Figure 2-7 Menu 1 – General Setup
Menu 1 - General Setup
System Name= p100ih
Location= branch
Contact Person's Name= JohnDoe
Location= branch
Contact Person's Name= JohnDoe
Press ENTER to Confirm or ESC to Cancel: