ZyXEL Communications ZyXEL G-560 사용자 설명서

ZyXEL G-560 User’s Guide

Chapter 6 Wireless Screens

81

The following table describes the labels in this screen.

Table 19   MAC Filter

Active

Select the check box to enable MAC address filtering and define the filter action for 

the list of MAC addresses in the MAC address filter table. 
Select Allow the following MAC address to associate to permit access to the G-

560, MAC addresses not listed will be denied access to the G-560.
Select Deny the following MAC address to associate to block access to the G-

560, MAC addresses not listed will be allowed to access the G-560.

#

This is the index number of the MAC address.

MAC Address

Enter the MAC addresses (in XX:XX:XX:XX:XX:XX format) of the wireless station 

that are allowed or denied access to the G-560 in these address fields.

Apply

Click Apply to save your changes back to the G-560.

Reset

Click Reset to begin configuring this screen afresh.

In a wireless network, the wireless clients must have the same SSID and security settings as 
the access point (AP) or wireless router (we will refer to both as “AP” here) in order to 
associate with it. Traditionally this meant that you had to configure the settings on the AP and 
then manually configure the exact same settings on each wireless client.

OTIST (One-Touch Intelligent Security Technology) allows you to transfer your AP’s SSID 
and WEP or WPA-PSK security settings to wireless clients that support OTIST and are within 
transmission range. You can also choose to have OTIST generate a WPA-PSK key for you if 
you didn’t configure one manually.

Note: OTIST replaces the pre-configured wireless settings on the wireless clients.

You must enable OTIST on both the AP and wireless client before you start transferring 
settings.

Note: The AP and wireless client(s) MUST use the same Setup key.

You can enable OTIST using the Reset button or the web configurator. 

If you use the Reset button, the default (01234567) or previous saved (through the web 
configurator) Setup key is used to encrypt the settings that you want to transfer.