Alcatel Carrier Internetworking Solutions Switch/Router 사용자 설명서

Page 35-13

The slots in the messages within the following table are all zero based. That is, Slot 1 will be 
displayed as “Slot 0,” Slot 2 will be displayed as “Slot 1,” etc.

Problem  deleting  SLP  port
xxx, errno=xx

Reboot the system, then use the Boot Line configuration to
force SLIP down at the boot line (refer to Appendix A “The
Boot Line Prompt”).

xxx in slot

Remove the module from the slot.

xxx  needed  to  be

The module appears dead. Remove the module from the slot
and replace with a known good module.

The software has discovered a dead task. The system will
reboot automatically.

The system encountered an unexpected condition. Reboot the
switch.

The system is confused. Clear the system by rebooting it.

This may indicate a bad MPX. Try power cycling.

xxx 

This may indicate a bad MPX. Try power cycling.

This may indicate a bad module in slot xxx. Try power cycling.

Reboot the system.

Try power cycling. If the problem remains, remove the module
and try another slot.

xxx  has

Try power cycling. If the problem remains, remove the module
and try another slot.

Reset the clock by using the 

command. 

Change stop bits by configuring boot line (refer to Appendix A
“The Boot Line Prompt”).

This message appears only once if the configuration file is
removed.