Alcatel Carrier Internetworking Solutions Switch/Router 사용자 설명서

Page A-2

Perform the following steps to reach the Boot prompt.

1. Connect an 

ASCII

 terminal (or computer with a terminal emulator) to the console port on 

the 

MPX

. The default communication parameters are:

• 9600 bps

• 8 data bits

• 1 stop bit

• no parity

• no hardware flow control (Microsoft Windows 95)

2. Turn on the switch.

3. You should see text scrolling on the terminal, indicating that the boot is starting. If you do 

not see any text within a few seconds of turning on the switch press the 

 key. If 

you still do not see any text on the screen, verify your connections, turn off the switch, 
and turn it back on again.

4. Once the boot process starts you have approximately two (2) seconds to interrupt the 

boot. Press any key during this time to enter the Boot prompt.

♦ Note ♦

MPXs

 in redundant configurations should not be 

stopped during the boot process. If you must do this, 
remove one of the 

MPXs

 while configuring the other.

The following screen prompt displays.

See the following section for documentation on basic Boot prompt commands. If you are 
configuring an Omni Switch/Router see Configuring a Switch with an MPX on page A-7.